|
Creation of special shock tubes and investigation of cumulation of liquid cylindrical shells in a rotating system
V. K. Kedrinskii
|
5–10 |
|
|
Free interaction of the flow in a laminar boundary layer with an upstream moving expansion wave
I. I. Lipatov, V. N. Petruhanov, G. M. Timofeev
|
11–15 |
|
|
Effects of the laser–water-jet processing of silicon carbide
Y. L. Chen, X. Li, X. Chen, H. Li, X. Xu
|
16–22 |
|
|
Generation of two-dimensional unsteady motion in a viscous incompressible fluid of finite depth
P. Kundu, B. N. Mandal
|
23–32 |
|
|
Search for stationary Poiseuille flows for an incompressible polymer fluid in channels with perforated walls
A. M. Blokhin, R. E. Semenko
|
33–41 |
|
|
Motion of an aqueous polymer solution with a free boundary
O. A. Frolovskaya
|
42–49 |
|
|
Device for creating a pressure differential using differential pumping
E. V. Domarov, Yu. I. Golubenko, N. K. Kuksanov, R. A. Salimov, S. N. Fadeev, I. K. Chakin
|
50–56 |
|
|
Effect of the intensity of mechanical processing of bronze particles on the characteristics of coatings formed by the method of cold gas-dynamic spraying
A. E. Chesnokov, S. V. Klinkov, V. F. Kosarev, A. V. Smirnov, V. S. Shikalov
|
57–64 |
|
|
Experimental study of effectiveness of reinforced vibration absorbing coatings
V. Yu. Kirpichnikov, A. P. Koshcheev, A. I. Syatkovskii
|
65–70 |
|
|
Rapid flutter analysis for low-aspect-ratio wings with a control surface
M. Basiri, H. Farrokhfal, M. Mosayebi, R. Koohi
|
71–79 |
|
|
Evolution of bed forms produced by clarified turbulent flow over a non-cohesive bed
K. S. Koroleva, I. I. Potapov
|
80–88 |
|
|
Enhancing viscous oil recovery in the microbubble filtration mode using supercritical fluid systems
A. V. Radaev, A. N. Sabirzyanov
|
89–96 |
|
|
Two-layer stationary creeping thermocapillary flow in a three-dimensional channel
V. K. Andreev, E. N. Lemeshkova
|
97–104 |
|
|
Thermodynamic calculation of the natural gas pressure reduction in a turboexpander
O. M. Sokovnin, N. V. Zagoskina, S. N. Zagoskin
|
105–112 |
|
|
Dual variational model of the temperature state of the disk of a unipolar generator
V. S. Zarubin, V. N. Zimin, G. N. Kuvyrkin, I. Yu. Savelyeva
|
113–121 |
|
|
Coupled fracture model of elastoplastic materials based on a kinetic equation of damage accumulation and the Pisarenko–Lebedev strength criterion
V. G. Bazhenov, S. L. Osetrov, D. L. Osetrov, A. A. Ryabov
|
122–129 |
|
|
Model of change of an ejection angle in the case of penetration of an impactor into a massive target
V. A. Goloveshkin, N. N. Myagkov, T. A. Shumikhin
|
130–137 |
|
|
Sudden loading of an elastoplastic rod interacting with the environment
A. Begmatov, N. T. Mamatova
|
138–152 |
|
|
Electrical conductivity of fractured materials: Hydrodynamic analogy
L. I. Stefanovich, È. P. Fel'dman
|
153–161 |
|
|
Investigation of the thermal stressed state of a hydrogen recovery reactor
I. V. Kudinov, A. A. Pimenov, G. V. Mikheeva
|
162–174 |
|
|
Vibration analysis of a viscoelastic graphene sheet exposed to an in-plane magnetic field using the nonlocal strain gradient theory
M. Pang, Y. Fang, Y. Q. Zhang
|
175–185 |
|
|
Nonlinear parametric oscillations of a longitudinally reinforced orthotropic cylindrical shell filled with a viscous liquid
I. T. Pirmamedov, F. S. Latifov, A. I. Khudieva
|
186–198 |
|
|
Impact analysis of countersunk bolt parameters on the load-bearing capacity of a ceramic matrix composite and superalloy joint
Q. Sun, Sh. Zhao, Yu. Zhang, Ch. Lv, X. Sun, J. Jia, M. Li
|
199–206 |
Contact us: